Vernier EasyData Guidebook Manual de usuario descargar pdf (Pagina 49)

48 EasyData Guidebook

Creating a New Calibration using a Single Point

This calibration method defines a new y-intercept, leaving the existing slope unchanged.

Adjusting a barometer to match the local barometric pressure is a good example of using

the Single Point calibration. The example below is using a force sensor connected to a

LabPro.

1. From the EasyData main screen, select Setup, and

then select CH1: (or the appropriate channel).

2. Select

from the Sensor Setup screen.

3. Select

. A menu is displayed showing the different

calibration methods.

4. Select Single Point Live….

5. Place your sensor into the necessary condition for the

calibration point (e.g. a force sensor with a known mass

hanging from it). Monitor the displayed Potential (V).

When the value is stable, select

6. Enter the known value for the calibration condition (e.g.

1.96 N for a 200 g mass), and select

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 66 67

Sin comentarios

Vernier EasyData Guidebook Manual de usuario Pagina 49